The Starter Home Studio Stack (2026): Interface, Mic, Headphones and Cables

A complete beginner home studio: one interface, one mic, closed-back headphones, a cable and a stand that work together, plus budget-friendly swaps.

By
Sajime
Published
Reading time
4 min

DisclosureWe may earn a commission when you buy through links on this site, at no extra cost to you. As an Amazon Associate we earn from qualifying purchases.

Our picks at a glance

No.1The interface
Focusrite

Focusrite Scarlett Solo (4th Gen)

One mic input and one instrument input cover what a singer-songwriter needs. It runs on USB-C bus power and has phantom power for a condenser mic.

Inputs
1 mic preamp (XLR), 1 instrument/line input
Outputs
2 balanced line outputs, 1 headphone output
Conversion
24-bit / up to 192 kHz
No.2The microphone
Audio-Technica

Audio-Technica AT2020

A very common first studio condenser. Good for vocals and acoustic guitar, and it runs on the interface's phantom power.

Type
Condenser, cardioid, side-address
Frequency response
20 Hz – 20 kHz
Max SPL
144 dB
No.3The headphones
Audio-Technica

Audio-Technica ATH-M20x

Closed-back, so the backing track in your ears doesn't bleed into the vocal mic while you record.

Type
Closed-back dynamic
Driver
40 mm
Frequency response
15 Hz – 20 kHz
No.4The cable
Hosa

Hosa HMIC-010 Pro Microphone Cable (10 ft)

A 10 ft XLR cable with REAN (by Neutrik) connectors. Ten feet lets you put the mic on a stand away from your computer's fans.

Connectors
REAN XLR3F to REAN XLR3M
Length
10 ft
Conductors
20 AWG oxygen-free copper
No.5The stand
On-Stage

On-Stage MS7701B Euro Boom Microphone Stand

A tripod stand with a 30-inch boom, so the mic can reach over a desk or keyboard to mouth height.

Base
Tripod
Boom length
30 in (removable)
Height
32 – 61.5 in

A complete starter home studio needs five things: an audio interface (Focusrite Scarlett Solo 4th Gen), a microphone (Audio-Technica AT2020), closed-back headphones (Audio-Technica ATH-M20x), an XLR cable and a mic stand. That’s enough to record vocals, acoustic guitar, voice-overs or a solo podcast, one source at a time. We picked entry-level parts that work together. Prices move, so check the current total at the shop before you buy. Below is why each piece is here, what to swap, and when to upgrade.

How the stack connects

The signal path is short: mic → XLR cable → interface → USB-C → computer. Your headphones plug into the interface, so you hear yourself with no delay.

  • The AT2020 is a condenser, so it needs phantom power. The Scarlett Solo has it. Switch it on before you record and off before you unplug the mic.
  • The Scarlett Solo has one mic input and one instrument input. You can record a vocal and a guitar plugged straight in at the same time, but not two mics.
  • The interface runs on USB-C bus power, so there’s no power supply to plug in.

1. The interface: Focusrite Scarlett Solo (4th Gen)

Focusrite

Focusrite Scarlett Solo (4th Gen)

The simplest way to record one mic and one guitar at the same time. USB-C, bus powered, with Focusrite's Air mode.

Inputs
1 mic preamp (XLR), 1 instrument/line input
Outputs
2 balanced line outputs, 1 headphone output
Conversion
24-bit / up to 192 kHz

If you record one mic at a time, one mic input is all you need. Focusrite lists 24-bit/192 kHz recording, 57 dB of mic preamp gain and the Air mode (Presence and Harmonic Drive) for the 4th Gen Solo. It also comes with a DAW bundle, which helps a lot on a tight budget.

Watch out: 57 dB of gain is plenty for a condenser like the AT2020. It’s on the low side for very quiet dynamic mics like the Shure SM7B. That’s why this stack pairs it with a condenser.

Budget swap: the Behringer UMC202HD is a common budget alternative, and it gives you two mic inputs, which helps if you ever podcast with a guest.

2. The mic: Audio-Technica AT2020

Audio-Technica

Audio-Technica AT2020

The best-known entry-level studio condenser. Side-address cardioid with an XLR output; needs phantom power.

Type
Condenser, cardioid, side-address
Frequency response
20 Hz – 20 kHz
Max SPL
144 dB

Audio-Technica’s spec sheet lists the AT2020 as a side-address cardioid condenser with a 20 Hz – 20 kHz frequency response. A condenser catches more detail than a dynamic mic, which suits sung vocals and acoustic guitar. The trade-off? It also catches more of your room.

Swap for noisy or echoey rooms: the Shure SM58 is a dynamic mic. It doesn’t need phantom power and picks up less of the room. If your room has bare walls or street noise, it’s the safer pick. Our dynamic vs condenser guide explains why.

3. The headphones: Audio-Technica ATH-M20x

Audio-Technica

Audio-Technica ATH-M20x

Entry-level closed-back studio headphones. Closed back keeps the click track out of your vocal mic.

Type
Closed-back dynamic
Driver
40 mm
Frequency response
15 Hz – 20 kHz

For recording, you want closed-back headphones. Open-backs leak the backing track into the mic. The ATH-M20x is Audio-Technica’s entry closed-back studio model. Audio-Technica lists 40 mm drivers, a 15 Hz – 20 kHz response and a fixed 3 m cable, so treat the cable with some care. Not sure about open vs closed? See open-back vs closed-back studio headphones.

4. The cable: Hosa HMIC-010 (10 ft)

Hosa

Hosa HMIC-010 Pro Microphone Cable (10 ft)

10 ft XLR female to XLR male mic cable with REAN (by Neutrik) connectors. Connects the mic to the interface.

Connectors
REAN XLR3F to REAN XLR3M
Length
10 ft
Conductors
20 AWG oxygen-free copper

You need one XLR (female) to XLR (male) cable between the mic and the interface. The AT2020 doesn’t come with one. Ten feet gives you room to put the mic away from your computer and its fan.

5. The stand: On-Stage MS7701B

On-Stage

On-Stage MS7701B Euro Boom Microphone Stand

Tripod mic stand with a 30-inch boom, so you can angle a vocal mic over a desk or keyboard.

Base
Tripod
Boom length
30 in (removable)
Height
32 – 61.5 in

A boom stand puts the mic at mouth height, whether you stand or sit at a desk. On-Stage lists a tripod base and a 30-inch boom for the MS7701B. If you only record speech at your desk, a desk-clamp boom arm works too.

Nice-to-have extras (when budget allows)

  • Pop filter: cuts down “p” and “b” pops on vocals. Cheap, and really useful with a condenser.
  • Shock mount: reduces rumble from the floor and desk.
  • Acoustic treatment: a few absorption panels behind and beside you often help more than a pricier mic. See acoustic treatment.

How to upgrade later

  1. Second mic input: move to a two-input interface like the Focusrite Scarlett 2i2 4th Gen. See our best audio interfaces for home recording.
  2. A better vocal mic: see our best microphones for vocals at home.
  3. The computer: if your laptop struggles with plugins, see our best laptops for music production.
  4. Monitors: add a pair once you start mixing seriously. Our best studio monitors for small rooms is a good place to start.

Bottom line

Interface, mic, closed-back headphones, cable and stand. Those five pieces are the whole starter studio. Get the condenser if your room is fairly quiet and soft, the SM58 if it isn’t, and put any leftover money into a pop filter first.

How we tested

We haven't recorded with this stack yet. We built it from the makers' own specs and manuals (Focusrite, Audio-Technica, Hosa and On-Stage), checked that every part connects to the next, and read long-term owner reports on reliability. Once we've recorded vocals, guitar and speech through this exact setup, we'll add the clips and our notes here.

Frequently asked questions

Q1Can you build a home studio on a tight budget?

Yes, as long as you record one source at a time. An entry-level interface, a condenser or dynamic mic, closed-back headphones, one XLR cable and a boom stand are all you need. Prices move a lot, so add up the current total at the shop before you buy.

Q2Do I need studio monitors to start?

No. Closed-back headphones are enough to record and do a first mix, and they don't bleed into the mic. Add monitors later, once you start mixing seriously.

Q3Should a beginner buy a condenser or a dynamic mic?

A condenser like the AT2020 picks up more detail, and more of your room too. If your room is noisy or echoey (bare walls, hard floor), a dynamic mic like the Shure SM58 is more forgiving.

Q4What else do I need besides the hardware?

A computer and recording software (a DAW). Focusrite bundles Pro Tools Intro+, Ableton Live Lite and Cubase LE with the Scarlett Solo, so you can start without buying software. A pop filter is a cheap, useful extra for vocals.

Q5Will this stack work for podcasting?

For one person, yes. Two people talking at once need two mic inputs, so start with a two-input interface like the Focusrite Scarlett 2i2 instead, or see our two-person podcast stack.